Snapper Clean Sweep Twin Catcher Bedienungsanleitung PDF herunterladen (Seite 10)

Bag and Chute Installation

Figure 10. Install Lower Discharge Chute

A. Lower Chute

B. Knob, 5/16-18

C. Front Carriage Bolt, 5/16-18 x 3/4

D. Wing Nut, 5/16

E. Discharge Deflector

F. Rear Carriage Bolt, 5/16-18 x 3/4

G. Hinge Bracket

LOWER DISCHARGE CHUTE INSTALLATION

1. Lift discharge deflector up (E, Figure 10).

2. Place the front hole of the lower chute (A) onto

carriage bolt (C) as shown. Slide front edge of lower

chute (A) under hinge bracket (G).

3. Place the rear hole of the lower chute (A) onto

carriage bolt (F) as shown.

4. Secure knob (B) onto carriage bolt (C) as shown.

5. Secure wing nut (D) onto carriage bolt (F) as shown.

INSTALL COLLECTOR BAGS

1. Raise the cover (A, Figure 9).

2. Attach collector bags (B) using grass bag hanger (C)

to bag hanger post (D).

Note: It may be necessary to fold seat forward to allow

cover to stay in the raised position.

Figure 9. Install Collector Bags

A. Cover

B. Collector Bags

C. Grass Bag Hanger

D. Bag Hanger Post

1 2 ... 5 6 7 8 9 10 11 12 13 14

Keine Kommentare

Snapper Clean Sweep Twin Catcher Bedienungsanleitung Seite 10